一种CORS站高程序列噪声识别算法     

吉长东  吕广涵  张恒璟  崔东东 《测绘科学》2021,46(3):8-16

针对能量密度谱判断噪声与信号主导模态分界点性能不稳定的问题,该文提出基于夹角余弦的分界点判断方法。该方法首先利用EEMD对CORS站高程数据进行分解,其次计算原始信号与各阶模态分量的夹角余弦值,最后根据夹角余弦值的首次逆向转折位置判定噪声主导模态和信号主导模态的分界点。以4个CORS基准站近20年原始高程时间序列信号为研究对象,对噪声与信号模态分量分界点进行判定,实验结果表明采用基于夹角余弦的判定方法可以一次判断出噪声和信号模态分量的分界点。该方法应用到CORS站高程信号与噪声序列的识别中性能更加稳定。  相似文献   

利用FY-3C折射率对大气边界层高度的反演与分析     

朱洲宗  徐晓华  罗佳 《武汉大学学报(信息科学版)》2021,(3)

2013年中国发射了首颗进行全球导航卫星系统(global navigation satellite system,GNSS)掩星观测的气象卫星风云3号C星(Fengyun-3C,FY-3C),且已发布自2014年6月以来的FY-3C掩星大气产品,但目前还未见将其应用于大气边界层的相关研究。首次尝试利用FY-3C折射率产品确定边界层高度并进一步进行空间分布分析。结果表明,在小波协方差变换法基础上,进行尖锐度约束,能够确定FY-3C掩星低层大气折射率廓线中可能存在的突变,反演边界层高度。所得到的2015―2018年各年边界层高度全球分布在不同纬度及海洋和陆地上的差异基本体现了边界层与地表气候及地形的关系,但FY-3C折射率产品在低层大气的精度和垂直分辨率相对较低。因此,反演成功率总体上较低,反演结果对边界层高度空间分布细节特征的呈现仍有待提升。  相似文献   

浮力装置触发深海管道水平向整体屈曲效果的数值模拟研究     

曹洋  张淑华  孙林 《海洋通报》2019,38(6):719-726

海洋油气资源的运输主要通过海底管道进行,管道在工作时受到较大的温度荷载,会产生整体屈曲变形。深海管道设计中常采用人为装置触发一定程度的水平向整体屈曲变形,来释放轴向的温度应力,浮力装置是常用的触发方式之一。本文通过数值模拟研究,分析了不同浮力大小和不同浮力施加范围下,管道水平向整体屈曲的临界屈曲力,得出临界屈曲力随浮力大小和施加范围变化的情况;并研究了不同土体阻力下,浮力装置触发整体屈曲的效果。研究表明,水平向土体阻力较大时,浮力装置触发水平向整体屈曲的效果较好。浮力装置的触发效果对轴向土体阻力不敏感。  相似文献   

GNSS精密轨道产品不连续性分析及评估     

董志华  陈俊平  周旭华 《天文学报》2019,60(5):44-54

按照目前的国际规范, 高精度GNSS (Global Navigation Satellite System)轨道产品一般以天为周期进行发布, 提供给用户使用. 连续使用多天的产品存在不同天间的跳变问题. 利用德国地学研究中心(GFZ)、欧洲定轨中心(COD)、欧空局(ESA)、美国喷气试验室(JPL)以及上海天文台(SHA)共5个GNSS分析中心2013---2017年的轨道产品, 分析了轨道跳变的特性. 计算结果表明: GFZ、COD、ESA、SHA和JPL的3维轨道跳变平均分别为7.79cm、1.51cm、7.77cm、11.75cm和2.51cm. 轨道跳变序列的周期特性分析表明: 序列存在90d、120d、340d左右的显著周期项, 对应于海潮对地球自转的影响, 其振幅为数毫米至1cm左右. 表明精密轨道确定需要进一步精化该项模型; GPS的跳变序列还存在与卫星星座相关的175d和352d左右的交点年显著周期项. 此外, 针对COD产品外推轨道的分析, 验证了地球反照辐射压和太阳光压模型等动力学模型对轨道的差异.  相似文献   

Semi‐analytical solution to one‐dimensional consolidation for unsaturated soils with semi‐permeable drainage boundary under time‐dependent loading          下载免费PDF全文

L. Wang  D. A. Sun  A. F. Qin  Y. F. Xu 《国际地质力学数值与分析法杂志》2017,41(16):1636-1655

This paper presents semi‐analytical solutions to Fredlund and Hasan's one‐dimensional consolidation of unsaturated soils with semi‐permeable drainage boundary under time‐dependent loadings. Two variables are introduced to transform two coupled governing equations of pore‐water and pore‐air pressures into an equivalent set of partial differential equations, which are easily solved by the Laplace transform. The pore‐water pressure, pore‐air pressure and settlement are obtained in the Laplace domain. Crump's method is adopted to perform the inverse Laplace transform in order to obtain semi‐analytical solutions in time domain. It is shown that the present solutions are more general and have a good agreement with the existing solutions from literatures. Furthermore, the current solutions can also be degenerated into conventional solutions to one‐dimensional consolidation of unsaturated soils with homogeneous boundaries. Finally, several numerical examples are provided to illustrate consolidation behavior of unsaturated soils under four types of time‐dependent loadings, including instantaneous loading, ramp loading, exponential loading and sinusoidal loading. Parametric studies are illustrated by variations of pore‐air pressure, pore‐water pressure and settlement at different values of the ratio of air–water permeability coefficient, depth and loading parameters. Copyright © 2017 John Wiley & Sons, Ltd.  相似文献   

One-dimensional consolidation of soil under multistage load based on continuous drainage boundary     

Yi--> Tian  Wenbing Wu  Guosheng Jiang  M. Hesham El Naggar  Guoxiong Mei  Meijuan Xu  Rongzhu Liang 《国际地质力学数值与分析法杂志》2020,44(8):1170-1183

In engineering practice, a rapid loading rate can result in ground failure when the strength of soft soils is relatively low, and a multistage loading scheme is always utilized to deal with this situation. Firstly, under a multistage load and the continuous drainage boundary, an analytical solution of excess pore-water pressure and consolidation degree is obtained by virtue of the superposition formula of excess pore-water pressure, and a more general continuous drainage boundary under arbitrary time-dependent load is developed. Then, a comparison with existing analytical solutions is conducted to verify the present solution. A preliminary attempt on applying the continuous drainage boundary into the finite element model is made, and the feasibility of the numerical model for the one-dimensional consolidation under the continuous drainage boundary is verified by comparing the results calculated by FEM with that from present analytical solution. Finally, the consolidation behavior of soil is investigated in detail for different int erface parameters or loading scheme. The results show that, in land reclamation projects, a horizontal drain should be placed close to the boundary with a smaller interface parameter to improve the consolidation efficiency. The degree of consolidation is also related to the applied time-dependent load and interface parameters.  相似文献   

竖向高荷载作用下大直径超长钻孔灌注桩承载性能试验     

桑伟锋 《世界地质》2020,39(1):127-134

通过机场—西华高速大直径超长钻孔灌注桩大吨位竖向单桩静载试验,分析了该地区大直径超长钻孔灌注桩的承载性状以及荷载传递机理。试验结果表明:试桩的Q-S曲线呈缓变型,桩端承载力占总荷载的比例均<10%,即均表现为摩擦桩特性;试桩的侧摩阻力自上而下逐步发挥,侧摩阻力和桩端阻力异步发挥且互相耦合;大直径超长钻孔灌注桩桩侧摩阻力的发挥与土层性质、土层埋深及桩顶荷载水平有关;在高荷载作用下桩侧上部土层摩阻力具有不同程度的软化现象,而中下部土层侧摩阻力具有不同程度的强化现象,甚至即使在最大加载情况下,桩身下部土层的侧摩阻力也并未完全发挥,因此在根据规范计算超长桩承载力时,不同深度土层的侧摩阻力应乘以相应不同的修正系数。  相似文献   

岩石膨胀性试验注意事项探讨     

刘军  谷莉  郭程  卓慧英 《岩土工程技术》2020,(2):117-121

从室内试验的角度来探讨几类工程勘察中岩石常用膨胀性试验(自由膨胀率、膨胀力、侧向约束膨胀率、耐崩解)的注意事项,从野外取样、标准样品制取、试验操作、方法选择等方面进行了论述,力求减小试验误差,提高膨胀岩的试验水平,保证试验结果的准确性,并使膨胀岩膨胀性指标的测定方法更臻完善。  相似文献   

欠固结地层静止侧压力简化计算方法     

乔亚飞  逯兴邦  黄俊  丁文其 《岩土力学》2020,41(11):3722-3729

大量工程实践表明：正确预估欠固结地层的静止侧压力大小对工程的稳定性分析和安全设计十分重要。因此，通过理论分析和数值模拟深入探讨了固结排水过程中地层侧向压力的变化规律，建立了静止侧压力与超固结比OCR的联系，提出了等效静止土压力系数的概念和计算公式，形成了考虑OCR影响的欠固结地层静止侧压力简化计算方法，并用数值模拟和试验结果进行了验证。提出的等效静止土压力系数实现了欠固结地层和正常固结地层侧压力计算的统一。研究结果表明：欠固结地层的静止侧压力随超固结比OCR的增大而线性减小，且随土体有效内摩擦角的增大，OCR对侧向压力的影响越大。上述研究成果可为欠固结地层的土压力计算提供技术支撑。  相似文献   

Transient seepage analysis in zoned anisotropic soils based on the scaled boundary finite‐element method          下载免费PDF全文

Mohammad Hossein Bazyar  Abbas Talebi 《国际地质力学数值与分析法杂志》2015,39(1):1-22

The scaled boundary finite‐element method, a semi‐analytical computational scheme primarily developed for dynamic stiffness of unbounded domains, is applied to the analysis of unsteady seepage flow problems. This method is based on the finite‐element technology and gains the advantages of the boundary element method as well. Only boundary of the domain is discretized, no fundamental solution is required and singularity problems can be modeled rigorously. Anisotropic and non‐homogeneous materials satisfying similarity are modeled with no additional efforts. In this study, firstly, formulation of the method for the transient seepage flow problems is derived followed by its solution procedures. The accuracy, simplicity and applicability of the method are demonstrated via four numerical examples of transient seepage flow – three of them are available in the literature. Homogenous, non‐homogenous, isotropic and anisotropic material properties are considered to show the versatility of the technique. Excellent agreement with the finite‐element method is observed. The method out‐performs the finite‐element method in modeling singularity points. Copyright © 2014 John Wiley & Sons, Ltd.  相似文献